I have now taken possession of one of the units and so far it has proved very good.I had to stop it timing out after 5 mins, and had a bit of greif with the firewall but now all sorted.I have upgraded the firmware to the latest version aal13 just having a look around the xdl file and I notice that vectoring is showing as disable / disabled ? pretty sure this had some numbers after it on the previous version aal 7
============================================================================
VDSL Training Status: Showtime
Mode: VDSL2 Annex B
VDSL Profile: Profile 17a
G.Vector: Disable
Traffic Type: PTM Mode
Link Uptime: 0 day: 0 hour: 46 minutes
============================================================================
VDSL Port Details Upstream Downstream
Line Rate: 19.062 Mbps 79.998 Mbps
Actual Net Data Rate: 19.000 Mbps 79.999 Mbps
Trellis Coding: ON ON
SNR Margin: 15.6 dB 9.4 dB
Actual Delay: 0 ms 0 ms
Transmit Power: - 5.7 dBm 13.4 dBm
Receive Power: -20.7 dBm 0.0 dBm
Actual INP: 0.0 symbols 52.0 symbols
Total Attenuation: 14.9 dB 13.3 dB
Attainable Net Data Rate: 26.841 Mbps 94.810 Mbps
============================================================================
VDSL Band Status U0 U1 U2 U3 D1 D2 D3
Line Attenuation(dB): 14.9 13.6 15.4 N/A 11.1 15.6 22.5
Signal Attenuation(dB): 14.9 14.1 15.0 N/A 11.2 15.6 22.5
SNR Margin(dB): 15.4 15.5 15.6 N/A 9.4 9.5 9.5
Transmit Power(dBm):-19.5 -31.1 - 6.0 N/A 10.3 7.8 7.0
============================================================================
Does this indicate that it is disabled, it needs enabling, or is now deemed not necessary ? if I am to enable it some where, could someone please guide me as to where do I do it from ?, the line speed has dropped a few meg btw line stats now show max dwn at 74 previous 79 however upload has increased from 14 to 17
Regards
Ron