@ HPsauce
Yes, I have changed from the 1.02.14 that came with the router in Jan, to the 1.02.16 and back again using the router web i/f, no probs. Also, I have performed a factory reset procedure as per the manual.
@BritBrat
But when I try the *ky kitz procedure purely to be sure that I am completely overwriting EVERYTHING, the recovery utlity does not find the MAC code of the router (recovery utility, step 2 I think!, after finding the PC network card) it just sits there. Re-booting the router shows that the software has not been overwritten, The router is fine, its not hanging.
Perhaps this procedure only works with the *ky software in place first, although that does not seem logical.
Any ideas?
MC
>Are you putting it into the two flashing lights (flash recovery mode)? ------- YES
>Are you using XP? ----- YES
>Do you have the firmware and Recovery Utility in same folder? ----- YES
>Did you run "RmDrv.exe" first then "UpgradeWizard.exe"? ---- NO, thats not in the explanation , am trying it now
Edited as I did not answer all of britbrats Q's