Hi Guy's,
Having trouble getting Dslstats to login to a 1312-b10a set as a modem/bridge (Modified firmware from this forum) v1.00(AAJZ.16)C0 jumboF_oldtelnet.bin)), my router is an Asus AC86U running latest Merlin 384.10, I can access the webpage and manually telnet in fine using 2 different configs but DSLstats refuses to connect - unable to login, tried the following setups...
Basic config 1 - (no changes done on vmg1312) Changed only the router WAN page from 'get wan IP automatically' to manual and set 192.168.0.1 (1312 default IP) and 192.168.0.2 for the router IP - can then access modem webpage and telnet in fine from the lan - but DSLstats unable to login.
Advanced config 2 - On the 1312 setup an 'interface group' called bridge and assigned the VDSL Ptm0.1 to Lan port 1 (wan connection to router) and created a 'Vlan group' ID 2 called it DSlstats, as expected in 'home networking' I have a default setup - IP 192.168.0.1 and the bridge setup I created - IP 192.168.2.1 (as expected no longer a lan connection to the 1312), then got the routing in the router adjusted to connect the lan 192.168.1.x with 192.168.2.x subnet via...
Telnet into the router and added the following lines...
ifconfig eth0:1 192.168.2.253 netmask 255.255.255.0
iptables -t nat -I POSTROUTING ! -s $(nvram get lan_ipaddr) -d 192.168.2.0/24 -j SNAT --to 192.168.2.253
This now gives back full access again to the lan like the basic config 1 and now to 192.168.2.1 - can access 1312 webpage and manually telnet in fine but again DSLstats says unable to login (changed login details to the new 192.168.2.1 IP)
If i connect my laptop direct to the vmg1312 and set the static ip of 192.168.1.10 to the laptop, DSLstats (running on the laptop) connects fine when using either basic (no changes on modem) or advanced config setups.
Any idea's?
Thanks.
Edit: Resolved by logging in via 'supervisor' account