Two buildings next to each other:
1.
A (6 flats).
2.
B (house).
Cellar/basement has a shared portion in which there is a new Distribution Point installed by BT and from where all 7 lines go to the street.
I've had BT Infinity installed for House B and was told that I could not get Infinity 2.
DSL Checker was
previously showing max clean speads of circa 40-50 down and 6-10 up. I am actually getting the top end of these speeds - great!
Now, however, checking the line phone number that I was given (I haven't tested the phone as I do not use the phone), the DSL checker for some reason shows the following very low numbers:
Yet, when I check the address of B, it shows numbers similar to what I am actually getting:
HOWEVER, when I check ANY of the flats in A, it shows much higher numbers:
So what the hell is happening?
Why is House B getting a lower speed than all the flats on A when they are on the same DP??
My theory is.. there used to a be a line in House B many years ago and it was disconnected (i.e. not used for over a decade), yet the address for B still remains on the system as it is a property and is what has been used for the DSL look-up and Infinity install. However, B is ACTUALLY on the new DP as all the flats which are all new addresses.
What do you guys think? I basically want to get on the fastest possible fibre if it is available to me!