hello, I've successfully upgraded and rooted to 1.1.0_002 on DGA4132.
My active profile is bank 2 and, if I understood well, it is not the best scenario for disaster recovery via BOOTP.
How can I switchover to bank 1 and have 1.1.0? (actually I have on bank 1 1.0.3, because I did double firmware flash as described in guide). Can I upgrade firmware and retain configuration?
My actual configuration is bridge mode (I have a business grade firewall on a business VDSL - no TIM) so that the static IP is fully managed by the firewall.
I've created a single interface only for bridging on combo port, so that the firewall uses it for PPPoE and the remain ports act like a separated switch where I can manage the technicolor and attach other devices. In addition to this I can use it like an access point and also have VoIP enabled without having wan traffic mixed with lan traffic.
But I read in this thread that wansensing should be disabled for bridging, while mine is active. Why do I need to disable it?
I think that my configuration is a smarter way to use the bridge mode, but I can do it only via SSH.
I've looked inside dga4131_unlocked GUI, but the bridgemode_helper.lua puts everything in bridge (DSL with WIFI with LAN) discarding what I wrote before.
May someone can help me to write a new bridgemode_helper.lua, so that I can (and not only me) setup this "combo bridge mode" with the GUI?
The files that I've modified are:
/etc/config/network:
config interface 'wan'
option demand '0'
option macaddr 'xxxxxxxxxxxxx'
option ipv6 '0'
option keepalive_adaptive '0'
option ifname 'wanptm0'
option proto 'bridge'
option auto '1'
config config 'config'
option wan_mode 'bridge'
-----------------------------------------------------
config interface 'lan'
option type 'bridge'
option proto 'static'
option netmask '255.255.255.0'
option ip6assign '64'
option force_link '0'
option ipv6 '0'
option ifname 'eth0 eth1 eth2 eth5'
option pppoerelay '<set by script>'
option ipaddr '192.168.1.1'
config interface 'combo'
option type 'bridge'
option proto 'static'
option netmask '255.255.255.0'
option ip6assign '64'
option force_link '0'
option ipv6 '0'
option ifname 'eth3 wanptm0'
option ipaddr '192.168.0.1'
/etc/config/firewall
config zone 'combo'
option name 'combo'
option input 'ACCEPT'
option output 'ACCEPT'
option forward 'REJECT'
option mtu_fix '1'
option wan '0'
option _key '????what is it????'
list network 'combo'
--------------------------------------------
/etc/config/dhcp
config dhcp 'combo'
option interface 'combo'
option dhcpv6 'server'
option ra 'server'
option ra_management '0'
option ra_mininterval '200'
option ra_maxinterval '600'
option ra_lifetime '1800'
option ra_hoplimit '64'
option force '1'
option leasetime '21600s'
list dhcp_option 'tag:cpewan-id,vi-encap:3561,6,"4132"'
list dhcp_option 'tag:cpewan-id,vi-encap:3561,5,"xxxxxxxxxx"'
list dhcp_option 'tag:cpewan-id,vi-encap:3561,4,"xxxxxx"'
list dhcp_option '6,192.168.0.1'
option dhcpv4 'server'
option start '10'
option limit '11'