This is what you need :
- Download
autoflashGUI to downgrade/upgrade your firmware. This is also used to unlock your firmware if you select the firmware 1.0.3.
- Download your firmware from my MEGA repository (see my signature at the bottom). Download both versions
1.0.3 and the
1.1.0 and put both files in the autoflashgui folder.
- Download an unlocked GUI for your router, in order to be able to configure it for your ISP.
http://www.dga4132.tk1) With autoflashgui, flash the firmware 1.1.0
2) with autoflashgui, flash the firmware 1.0.3, configure it like in my screenshot below, don't forget to tick "
dga4132 1.0.3 root inactive" :
it will flash the firmware 1.0.3 and reboot the modem, root it, root the inactive bank where is located the firmware 1.1.0, and reboot again but this time with the firmware 1.1.0 (root and ssh enabled).
3) now you can access the router with putty (login/pass = root/root) and winscp. if you're an advanced user and have some openwrt knowledge, you can go directly to the /etc/config/ folder and start configuring your modem/router. if not then you have to install an unlocked GUI to configure it from your browser.
4) with winscp copy the unlocked gui file
dga4132_unlocked.tar.gz in the
/tmp folder of the router
5) from putty run these comands :
tar -zxvf /tmp/dga4132_unlocked.tar.gz -C /
/etc/init.d/rootdevice force
/etc/init.d/rootdevice force
at this point your modem should reboot, so just wait...the content of Bank_1 will be copied into bank_2 or vice versa, and bank_1 will be set as the active bank_1. In case of big problem it's always good to be on bank_1 active as it will let you reflash the modem with TFTP.
If you see some errore messages just ignore them, it's not important. it's just because you don't have a WAN ip address as your ISP is not configured yet.
6) you can now start configuring your modem from the GUI.