Under setup wizard I notice that there is no bridge option.
Under internet access when you set connection type bridge we can see it now correctly changes wansensing and changes the protocol to bridge under the wan interface in /etc/config/network so the tile is displayed correctly.
However this would not fully set the bridge mode as it seems this would be done by "bridgedmode_helper.lua" but where is that called from?
Below is the section of it which disables wifi etc and creates the actual bridge "local ifnames = 'eth0 eth1 eth2 eth3 eth5 wanptm0'"
although from the previous posts we can see this does not work when there is no vlan so for me it should be ptm0 not wan ptm0.
function M.configBridgedMode()
local success = false
local ifnames = 'eth0 eth1 eth2 eth3 eth5 wanptm0'
success = proxy.set({
["uci.wansensing.global.enable"] = '0',
["uci.network.interface.@wan.enabled"] = '0',
["uci.network.interface.@wan.auto"] = '0',
["uci.network.interface.@wan6.enabled"] = '0',
["uci.network.interface.@wwan.enabled"] = '0',
["uci.wireless.wifi-device.@radio_2G.state"] = '0',
["uci.wireless.wifi-device.@radio_5G.state"] = '0',
["uci.mmpbx.mmpbx.@global.enabled"] = '0',
["uci.dhcp.dhcp.@lan.ignore"] = '1',
["uci.cwmpd.cwmpd_config.state"] = '0',
["uci.mobiled.device_defaults.enabled"] = '0',
["uci.network.interface.@lan.ifname"] = ifnames,
["uci.network.config.wan_mode"] = 'bridge',
})