Hi guys,
Used to have a pbx system installed, but have now moved to a much smaller office and don't require the full features of a pbx anymore.
I've ran 3 extensions from the nte faceplate (using a termination block)
My question is, can I use the pbx phones still? I've plugged them into the sockets, and theres no dial tone. I do however have dialtone in all 3 sockets using my normal analogue phone.
Do I have to use pin 3 for the bell wire to get dialtone? The phones were previously powered off the pbx system, and I dont have psu's for the phones (Have just ordered some) but didn't think i'd need a supply for them to have dialtone?
The connector is an rj11 on the end that goes into the phone, and a normal telephone connection on the other end going into extension socket.
Hope this makes sense
Thanks