You can use the following command:
xdslctl info --vectoring
xdslctl: ADSL driver and PHY status
Status: Showtime
Last Retrain Reason: 1
Last initialization procedure status: 0
Max: Upstream rate = 37534 Kbps, Downstream rate = 93184 Kbps
Bearer: 0, Upstream rate = 11007 Kbps, Downstream rate = 55039 Kbps
Bearer: 1, Upstream rate = 0 Kbps, Downstream rate = 0 Kbps
Vectoring state: 1
VCE MAC Address: 0:10:fc:20:0:0
Total error samples Ethernet pkts sent: 131290
Total error samples Ethernet pkts discarded: 0
Total error samples statuses sent: 65645
Total error samples statuses discarded: 0
I don't know all state codes but on my line I saw this:
Vectoring state: 1 vectoring enabled
Vectoring state: 5 without vectoring (Without vectoring "VCE MAC" and "Total error samples" are all zero.)
Maybe codes 2,3 or 4 indicate vectoring friendly mode.
Hi. I'm just registered on this forum cause I hope you can help me to understard better whats happened to my line.
I live in Italy and some weeks ago after a disconnection the Zyxel VMG-8924 shows "G.Vector enable" but I haven't see any improvement in terms of SNRm or max attainable rate:
Through the latest version of DSLstats I see "1 [Vect_Full]" from Stats:
But in the Vectoring tab all the counter "total error samples" are
always stuck to zero as you can see:
So do you think that G.Vector is really working or not? How much improvement did you see on your line since Vectoring has been enabled?
Thanks to any comment.