Hello,
Im new to the forum but have been using this site for many years, love the information available on here!
I do come with a question and not a solution though!
But first a little background information.
I had FTTC installed about 10 days ago at home. Was previously getting around 3.5mbps down and 0.5mbps up on a TalkTalk provided ADSL line. Went with TalkTalk as at the time they were the only ISP providing 21CN speeds at my exchange. When I first moved in about 3 years ago I had a standard 8mbps ADSL line and was getting an unusable 0.5mbps down and non-existent up!!
Now I am seeing around 19mbps down and 3mbps up. An excellent improvement!
Currently Zen Internet is my provider. I have three other FTTC circuits at my office, which run very well indeed at around 72mbps down and 17mpbs up. ISP's at the office are Zen, Plusnet and BT. The Zen line seems to outperform the other connections. Thats a different thread though!
I have just acquired a DrayTek Vigor 130 in the hope of squeezing a little more speed out of my home connection.
My line length is just over a mile so I am not really expecting much more than what I have now. When Openreach came to install the modem, they left me with an ECI modem, I am not keen on those due to the G.INP issues a few months ago. I do have three HG612's that are unlocked. I borrowed one from the office and attached it to my home line to get some stats. Line looks OKish. Huge interleave depth on the downstream, 423 to be exact! Although I dont know how accurate that is, as from my understanding, if that was true then latency would be unbearable! Latency is pretty good for the line length, a ping to bbc.co.uk from a terminal shows an average of 25ms. Currently G.INP is not enabled on the cabinet, which is a Huawei.
So now onto the Vigor 130. Its a nice looking modem, well built. The question is, can I access the web gui of the Vigor 130 without having to connect directly to it via ethernet? Quick Start manual says to access web gui I would need to set an IP address of 192.168.2.10 on a computer and that the Vigor 130 is on 192.168.2.1.
I note that there is a LAN section on the web gui of the 130 from pictures I have seen on the internet, but I have not yet directly connected to the Vigor 130 to see if I can set a static IP for the 130 on the same subnet as the rest of my network to allow me to access the web gui from any device, without the need of a direct connection. Just thought I would ask here before I go messing about with it.
Finally, with the HG612 I was syncing a little higher, however, pings have improved by about 10ms since using the Vigor 130. Will give it a few more days and see what its like. Hopefully G.INP will get enabled on the cabinet in due course, the cabinet itself only went live about two weeks ago.
Thanks for reading and also for any info received.
DoZZa