Kitz ADSL Broadband Information
adsl spacer  
Support this site
Home Broadband ISPs Tech Routers Wiki Forum
   Compare ISP   Rate your ISP
   Glossary   Glossary
Please login or register.

Login with username, password and session length
Advanced search  


Author Topic: DGN2000 - Flashing DGTeam Firmware.  (Read 5473 times)


  • Reg Member
  • ***
  • Posts: 159
DGN2000 - Flashing DGTeam Firmware.
« on: July 18, 2010, 04:04:57 PM »

Hi all

Could someone please guide me in the right direction.
Iíve just bought a dgn2000 and I'd like to flash it with DGTeam firmware using the Netgear dg834 recovery utility. 
My problem is, I donít know how to get the router into the recovery mode if that's the correct term?

It was easy on my old dg834gt if you inserted a pin into the reset hole on the back and turn on the power the
two lights on the front would blink and you were ready to go, the dgn2000 doesnít have a reset hole on the rear so Iím stumped.

I really donít want to end up with a door stop so any advice would be appreciated.



  • Administrator
  • Senior Kitizen
  • *
  • Posts: 39663
  • Penguins CAN fly
    • DSLstats
Re: DGN2000 - Flashing DGTeam Firmware.
« Reply #1 on: July 18, 2010, 04:42:25 PM »

I think from memory that you have to press the two buttons on the side while powering up the router.


  • Kitizen
  • ****
  • Posts: 1356
Re: DGN2000 - Flashing DGTeam Firmware.
« Reply #2 on: July 18, 2010, 06:08:35 PM »

What is the next thing you need to know?

Identify the "reset buttons" on the device itself. Every manufacture will have "reset button hole" which can be hard to find. Below is various of mix manufacture phots showing the where you might find "reset button hole". Please refer to manufacture/model manual which usually indicates were you might expected.

**For NETGEAR model DGN2000 or similair model: Combination of Wireless button and WPS button on the side of the modemw will use as procedures

I have the 'locked to ISP firmware' problem.

I needed QoS from v1.1.8.0

I've found a nifty solution.

I was upgrading using DGN2000_V1.1.8.0.img and my router has V1.2.12TT (presumably TT for Talk Talk)

I renamed DGN2000_V1.1.8.0.img to DGN2000_V1.2.13TT.img and used that file to upgrade.


Now I have and QoS.

The old ones are the good ones!

Presumably this will work for other ISPs
« Last Edit: July 18, 2010, 06:17:26 PM by BritBrat »


  • Reg Member
  • ***
  • Posts: 159
Re: DGN2000 - Flashing DGTeam Firmware.
« Reply #3 on: July 18, 2010, 08:18:55 PM »

Brilliant thanks very much.   :)

« Last Edit: July 18, 2010, 09:01:17 PM by r2d2 »