Computers & Hardware > PC Hardware

How to install a CISS unit for the Epson R300

<< < (4/4)

RussellS:
Thanks for that.

I've just had it all apart and it does look as though there isn't enough room to get the tubes out under the LCD panel. So I'm going to have to go the same way as you have but I will need to modify my center support bracket to allow the tubes to loop back on themselves without having too tight a bend in them which may restrict the ink flow.

I'll let you know how I get on.


Russell

oldfogy:
I was thinking about using a large paper clip to hold the tubes together.

Fold the tubes on top of each other.
Push through the centre of the paper clip.
Slide the clip down the tubes to create a gap at the bend.
Slide the fixing bracket between the gap in the tubes, and secure to the fixing bracket.
(Or just neatly tape the tubes together)

Don't forget, make sure you fix the centre bracket in exactly the same place as on my diagram, or else the tubes will either be too long and hang very loosely or be too tight and jam.

Navigation

[0] Message Index

[*] Previous page

Go to full version