Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[jid]

I have the above router.

How can I monitor the stats from it with software?

I have tried RouterStats but its all in JavaScript?

DMTv8 connects but says there is "No Such file or Directory"?

Is there anyway I can manually tell it were to work, or is there any alternative software that I could try?

Here is what the Debug brings up:-

DMT_INFO> ----- Connected ConnectionID(37764416) -----
DMT_RX>
BusyBox on (none) login:
DMT_TX> admin
DMT_RX> admin
Password:
DMT_TX> ****
DMT_RX>


BusyBox v0.61.pre (2007.06.13-04:30+0000) Built-in shell (ash)
Enter 'help' for a list of built-in commands.

#
DMT_TX> adslctl --version
DMT_RX> adslctl --version
adslctl: No such file or directory
#
DMT_TX> cat proc/cpuinfo
DMT_RX> cat proc/cpuinfo
processor               : 0
cpu model               : MIPS 4KEc V4.8
BogoMIPS                : 149.91
wait instruction        : no
microsecond timers      : yes
extra interrupt vector  : yes
hardware watchpoint     : yes
VCED exceptions         : not available
VCEI exceptions         : not available
#
DMT_TX> adslctl info
DMT_RX> adslctl info
adslctl: No such file or directory
#

[kitz]

>> I have tried RouterStats but its all in JavaScript?

When configuring routerstats most routers will show the yellow javascript warning symbol thing - its because routerstats reads from the raw htm

>> DMTv8 connects

I'm not sure it works with the G624T -   DMTtool relies on a BCM command adslctl which allows it to access certain information direct from the router.  If the router doesnt have the command then it wont work Im afraid.

[jid]

Oh I don't get a yellow thing, just blank.

It works behind CGI, but some detective work and I found the htm page, but there was just a load of javascript in the Source where the SNR etc should be.

Are there any alternatives to DMT or RouterStats?

[Azzaka]

Check the updated firmwares from router stats. The modem you have uses a Texas Instruments chip and therefore there will be a new code for it. Lats time i looked there was a new beta firmware on the whirlpool forums.