Kitz ADSL Broadband Information
adsl spacer  
Support this site
Home Broadband ISPs Tech Routers Wiki Forum
 
     
   Compare ISP   Rate your ISP
   Glossary   Glossary
 
Please login or register.

Login with username, password and session length
Advanced search  

News:

Author Topic: anyone familiar with Draytek products?  (Read 328 times)

111888

  • Member
  • **
  • Posts: 55
anyone familiar with Draytek products?
« on: February 11, 2024, 03:29:15 PM »

It shows bitswap is off on dsl stats, but when I telnet into the router it shows it is set to default 0, 0.

0 is default 1 is on, and 2 is off.

Shouldn't I have bitswap turned on?

Does anyone know the correct syntax to enter in telnet to turn bitswap on? for both upstream and downstream. I tried looking at guides and I can't figure out the correct syntax to enter.  im just a home user with 0 scripting experince.

attached screenshots.
Logged

Alex Atkin UK

  • Addicted Kitizen
  • *****
  • Posts: 5272
    • Thinkbroadband Quality Monitors
Re: anyone familiar with Draytek products?
« Reply #1 on: February 11, 2024, 05:32:09 PM »

Unless you get performance problems the longer you remain in sync, I'd ignore it.

I'm sure we've seen a few modems where for some reason they say bitswap off if the line has not been in sync for long, but then it suddenly shows on later, possibly after bitswapping has actually occurred.
Logged
Broadband: Zen Full Fibre 900 + Three 5G Routers: pfSense (Intel N100) + Huawei CPE Pro 2 H122-373 WiFi: Zyxel NWA210AX
Switches: Netgear MS510TXUP, Netgear MS510TXPP, Netgear GS110EMX My Broadband History & Ping Monitors
 

anything