Kitz ADSL Broadband Information
adsl spacer  
Support this site
Home Broadband ISPs Tech Routers Wiki Forum
   Compare ISP   Rate your ISP
   Glossary   Glossary
Please login or register.

Login with username, password and session length
Advanced search  


Author Topic: VMG1312-B10A G.Vectoring  (Read 1111 times)


  • Just arrived
  • *
  • Posts: 2
VMG1312-B10A G.Vectoring
« on: November 04, 2022, 02:41:43 AM »

Probably a stupid question, but I can't seem to find the answer. Is the vmg1312-b10a capable of g.vectoring or g.inp? If so how do I enable them?

Thanks :)


  • Senior Kitizen
  • ******
  • Posts: 12829
Re: VMG1312-B10A G.Vectoring
« Reply #1 on: November 04, 2022, 08:25:22 AM »

It supports both but it depends on the cabinet you are connected to whether you'll get them or not. If on a Huawei cabinet you should get G.INP by default but vectoring is only enabled on a very limited number of cabinets so you likely won't see it. If you are on an ECI cabinet then I'm afraid you won't have either available to you.
There's nothing you need to do on the VMG1312-B10A to enable them - if they are there you should get them.
BT FTTC 55/10 Huawei Cab - Zyxel VMG8924-B10A


  • Kitizen
  • ****
  • Posts: 4106
Re: VMG1312-B10A G.Vectoring
« Reply #2 on: November 04, 2022, 08:55:53 AM »

Both work, but neither are user configurable.

G.Vector (Vectoring) requires physical hardware to be installed on the DSLAM by the network operator and in the UK Openreach have only enabled on a tiny fraction of Huawei cabinets that were installed with BDUK funding.

G.INP is an error protection that is also controlled by the network operator.

In the UK G.INP should be available and enabled on all lines that are connected to Huawei cabinets.
The ECI cabinets do not have G.INP rolled out to them, excluding a few lines from previous trials.
« Last Edit: November 05, 2022, 10:17:26 AM by j0hn »
Talktalk FTTP 550/75 - Speedtest - BQM


  • Just arrived
  • *
  • Posts: 2
Re: VMG1312-B10A G.Vectoring
« Reply #3 on: November 04, 2022, 07:57:19 PM »

Thanks both of you :)