Kitz ADSL Broadband Information
adsl spacer  
Support this site
Home Broadband ISPs Tech Routers Wiki Forum
 
     
   Compare ISP   Rate your ISP
   Glossary   Glossary
 
Please login or register.

Login with username, password and session length
Advanced search  

News:

Author Topic: Patch panel cabling  (Read 210 times)

skyeci

  • Kitizen
  • ****
  • Posts: 1287
    • Zen ECI line stats
Patch panel cabling
« on: May 22, 2022, 06:17:14 PM »

So felt like a challenge after getting fttp recently and decided it was a good time to upgrade my cabling to cat6. The  5e I put in some years seems to works ok but in places it's looking a bit ropey as its all externally run back to my garage.

I decided to buy a wall mounted cat6 patch panel (12 port) as I only have 10 wired ports  in use. Its shorter than what you would find in say a 19inch cab. A cabinet seems overkill for my needs.

My question is related to how my cat6 should be presented at the patch panel. It's mounted vertically on the wall so can I run them all in from the top ??. On line video show the first cable but stops at that..

It's been a challenge in places getting the cat6 in as it's  so much thicker than the old 5e, but its going well  so far....

Anyone need a huge box of like new cat5e patch leads  ;D
« Last Edit: May 22, 2022, 08:20:57 PM by skyeci »
Logged
Zen 900 FTTP + Opnsense(i7 Qotom) with IPV6, 
click for stats
(ex FTTC/ECI)
click for line stats by pi3/Huawei VDSL