Kitz ADSL Broadband Information
adsl spacer  
Support this site
Home Broadband ISPs Tech Routers Wiki Forum
 
     
   Compare ISP   Rate your ISP
   Glossary   Glossary
 
Please login or register.

Login with username, password and session length
Advanced search  

News:

Pages: 1 [2]

Author Topic: Access Web GUI Draytek Vigor 130  (Read 2457 times)

meritez

  • Content Team
  • Kitizen
  • *
  • Posts: 1614
Re: Access Web GUI Draytek Vigor 130
« Reply #15 on: August 31, 2020, 09:26:08 AM »

Talktalk don't do PPP on VDSL, only DCHP/IPoE.

They do if it's a business VDSL connection.
Logged

Weaver

  • Senior Kitizen
  • ******
  • Posts: 11459
  • Retd s/w dev; A&A; 4x7km ADSL2 lines; Firebrick
Re: Access Web GUI Draytek Vigor 130
« Reply #16 on: August 31, 2020, 12:20:44 PM »

Talktalk wholesale does PPP when they are reselling their service; for example, other ISPs such as Andrews and Arnold use either TalkTalk wholesale or BT wholesale.
Logged

j0hn

  • Kitizen
  • ****
  • Posts: 4081
Re: Access Web GUI Draytek Vigor 130
« Reply #17 on: August 31, 2020, 12:28:52 PM »

Indeed, only Talktalk residential do DHCP.
Their business and wholesale lines do not.

The OP is on Talktalk residential.
Logged
Talktalk FTTP 550/75 - Speedtest - BQM

Maz_17

  • Just arrived
  • *
  • Posts: 1
Re: Access Web GUI Draytek Vigor 130
« Reply #18 on: February 06, 2024, 01:16:23 PM »

Hi, I was hoping I could take a look at the config as Iíve been trying myself for a while now to reach the Vigor WebGUI. Iíve followed the Netgate/pfSense how to access CPE/Modem from inside the firewall and still not able to reach the modem without plugging a laptop in directly to it and joining the 192.168.2.1/24 network.

My setup may be a little different tho, so itíll be interesting to see how this has been setup working for others if possible.

My current setup:
Vigor167 > managed switch (untagged port vlan 88) > managed switch > pfSense on Proxmox.

Internet works via bridge mode and am able to reach both managed switches.

Any thought
Logged

hushcoden

  • Reg Member
  • ***
  • Posts: 429
Re: Access Web GUI Draytek Vigor 130
« Reply #19 on: February 15, 2024, 02:17:46 PM »

I'm using OPNsense and it's pretty straightforward: assign the underlying physical interface used for PPPoE and configure it with the subnet used for modem management, create a GW and configure it to the modem IP, done (no need any outbound rules or any firewall rules on that interface).
Logged
Pages: 1 [2]
 

anything