Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[peppeg83]

Hi! Excuse me for may English, i have problemwith my connection! When the modem connect whit OVER interleaved channel bit rate: 2000 kb downstream I Have snr margin 6-7 db and so I can't navigate! but when the modem connect to 1500 kb I have a snr margin of 10-12db and so I can navigate, I know that some router modem (Netgear 834G) can setup the snr margin from TELNET! Can I do this with TELNET on my BIPAC 5200S?
THANK YOU!

[roseway]

Hi and welcome.

I don't think that this is possible. I use a Bipac 5200G, and I haven't found any telnet command which will change the target noise margin.

But I don't really understand why this is a problem for you. The connection should work normally if you connect at 2000 kbps and a 6 dB noise margin. Why can't you navigate?

You don't need to apologise for your English. Your English is fine.

[peppeg83]

Thank you for your reply!
But I can't navigate when the portant is over 2000 kbps and snr margin 6 db and line attenuation 50 db!
but when the modem connect to portant at 1500 kbps the snr margin is 10-12 db and line attenuation 42 db, is there a way to block the portant to 1500?
I know that the netgear 854g can do this with telnet or with DMT (DSL MODEM TOOL)

Thanks at all!

[roseway]

I'm afraid that I still don't understand why you can't use 2000 kbps with 6 dB margin. But anyway, I don't believe that it is possible to do what you want with the 5200S unfortunately. If you must have the lower speed and higher noise margin, then I think that your only option is to use a different router which does work with DMT.

[kitz]

>> I know that the netgear 854g can do this with telnet or with DMT (DSL MODEM TOOL)

Just to point out that its only the DG834G v4 that you can do this with.
Previous versions ( DG834G v1, v2, v3) cant.