Kitz ADSL Broadband Information
adsl spacer  
Support this site
Home Broadband ISPs Tech Routers Wiki Forum
 
     
   Compare ISP   Rate your ISP
   Glossary   Glossary
 
Please login or register.

Login with username, password and session length
Advanced search  

News:

Author Topic: Graph Sketch  (Read 134 times)

burakkucat

  • Global Moderator
  • Senior Kitizen
  • *
  • Posts: 27439
  • Over the Rainbow Bridge
    • The ELRepo Project
Graph Sketch
« on: September 30, 2019, 08:23:42 PM »

The Graph Sketch site has recently come to my attention.

A few days ago I was looking at the upper and lower limits of the logarithmic presentation of the transfer function (Hlog) of an xDSL circuit and the representation of the "no value is available" condition.

The last three paragraphs of Section 8.12.3.1, headed "Channel characteristics function per subcarrier (CCFps)", from ITU-T Rec. G.992.3 (04/2009) read as follows --

"The channel characteristics function Hlog(f) shall be represented in logarithmic format by an
integer number m(i), where i is the subcarrier index i = 0 to NSC 1. The m(i) shall be coded as a
10-bit unsigned integer. The value of Hlog(i Δf) shall be defined as Hlog(i Δf) = 6 (m(i)/10).

This data format supports an Hlog(f) granularity of 0.1 dB and an Hlog(f) dynamic range of
approximately +6 dB to 96 dB.

An Hlog(i Δf) value indicated as m(i) = 2^10 1 is a special value. It indicates that no measurement
could be done for this subcarrier because it is out of the PSD mask passband (as relevant to the
chosen application option see annexes) or in the BLACKOUTset (see clauses 8.13.2.4, 8.13.4.1
and 8.13.4.2) or that the attenuation is out of range to be represented."

As a consequence, I had an equation that I wished to visualise --

y = 6 - (((2^x) - 1) / 10)

On entering that equation, all was then revealed.
Logged
:cat:  100% Linux and, previously, Unix. Co-founder of the ELRepo Project.

Please consider making a donation to support the running of this site.