Kitz ADSL Broadband Information
adsl spacer  
Support this site
Home Broadband ISPs Tech Routers Wiki Forum
 
     
   Compare ISP   Rate your ISP
   Glossary   Glossary
 
Please login or register.

Login with username, password and session length
Advanced search  

News:

Author Topic: iMac Energy Saver  (Read 1076 times)

sevenlayermuddle

  • Helpful
  • Kitizen
  • *
  • Posts: 3990
iMac Energy Saver
« on: March 13, 2019, 09:25:13 AM »

Not sure anybody else on here uses iMac, but in case anybody is interested, I happened to notice that after "up"-grading to Mojave, mine was failing to sleep/standby, thus using a lot more electricity.

One underlying problem here is that there isn't a power led to look at, and so no easy way of telling if this 2017 iMac has actually entered any kind low power mode.   The screen switches off which would fool a lot of people into thinking is was now asleep,  but consumption stays unreasonably high, as CPU/memory/disks whatever seem to stay powered up.  I deduced that as I leave it connected via a plug-in watt meter and found that with Mojave, even after being idle from 5pm til breakfast time, it was still consuming 25-30W.  To quantify it as cash, it's going to be costing me something over £30 per year, or say £200 over its lifetime, just for sitting there looking pretty (the iMac, not me).  :(

The GUI offers only very limited control, I had to resort to command line to figure it out.  I don't think the command line parameters are officially documented, but the difference (from High Sierra) seems to be that a parameter named "standbydelay", which was set to 10800 seconds (3 hours) by default, has been replaced by "standbydelayhigh" and "standbydelaylow", which are each set to a staggering 86400 (24 hours) by default.  I think "high" and "low" are used for laptops, and refer to battery charge levels.  "sudo pmset standbydelaylow 10800", and same for "...delayhigh" seems to have restored sensible behaviour, consumption reducing to less than 2Watts, about 3 hours after I walk away.

I have also disabled (from the GUI) "power nap".  Not sure if that was essential, but seems sensible.  Also worth mentioning that after tweaking the GUI, the "pmset" tweaks sometimes go back to their default values.

ISTR that High Sierra also had (different) problems with energy-saving modes, that involved 'pmset' tweaks to make it work properly.
« Last Edit: March 13, 2019, 09:27:25 AM by sevenlayermuddle »
Logged

sevenlayermuddle

  • Helpful
  • Kitizen
  • *
  • Posts: 3990
Re: iMac Energy Saver
« Reply #1 on: March 14, 2019, 07:00:50 PM »

Update to above...

Iíve now reset to the defaults, with 24 hour standby delays and.... my iMac is behaving impeccably.   Consumption reduces to about 1-2W pretty much as soon as the display turns off, about 15 mins idle. :-[

Iím in truth none the wiser, as to why it was failing to reduce consumotion.   So annoying though, that there is no tell-tale power led, no way to tell if the energy saving mode is actually working, other than plugging it in through a power monitoring device.     :(
Logged
 

anything