Kitz ADSL Broadband Information
adsl spacer  
Support this site
Home Broadband ISPs Tech Routers Wiki Forum
 
     
   Compare ISP   Rate your ISP
   Glossary   Glossary
 
Please login or register.

Login with username, password and session length
Advanced search  

News:

Author Topic: Ethernet point-to-point link?  (Read 655 times)

phi2008

  • Reg Member
  • ***
  • Posts: 419
Ethernet point-to-point link?
« on: November 25, 2018, 02:53:13 PM »

Would like to connect a VDSL modem on one side of the room to a router on the other side of the room - without cable. Can I do this with powerline adapters or a wireless bridge?
Logged

licquorice

  • Reg Member
  • ***
  • Posts: 656
Re: Ethernet point-to-point link?
« Reply #1 on: November 25, 2018, 03:49:35 PM »

You can do it with Powerline adaptors.
Logged

Weaver

  • Addicted Kitizen
  • *****
  • Posts: 6774
  • Retd sw dev; A&A; 4 × 7km ADSL2; IPv6; Firebrick
Re: Ethernet point-to-point link?
« Reply #2 on: December 30, 2018, 03:05:18 PM »

You can do this with many wireless access points. I did so. You put one WAP into ‘client mode’ and it then logs into the say WPA2 network with the usual password and bridges stuff between its wired and wireless nics, ie. copies stuff in both directions.

I am extremely filled with vicious irrational loathing ;D for comms-over-mains technologies because of the possibility of causing interference to DSL and some top-end hi-fi and the possibility of leakage affecting neighbours as well.
Logged

chenks

  • Reg Member
  • ***
  • Posts: 617
Re: Ethernet point-to-point link?
« Reply #3 on: December 30, 2018, 03:39:20 PM »

You can do it with Powerline adaptors.

you could, i wouldn't advise it though.
powerline is susceptible to interference and speed drops.
Logged

j0hn

  • Kitizen
  • ****
  • Posts: 2295
Re: Ethernet point-to-point link?
« Reply #4 on: December 30, 2018, 06:27:46 PM »

Depending on the specific Powerline adapters used and the homes internal wiring, many get no problems at all from their use.

My homes electrical wiring and a power socket ran parallel up the wall to the incoming OpenReach line.
Powerlines caused very high FEC/Rtx_tx on my line when in use.
Removing that power socket and its wiring cured all issues. Using the Powerlines now has absolutely zero impact on my xDSL.

A number of others also have success using them but it does indeed cause considerable issues for many.
I've also seen comments that 1 brand caused issues with their broadband but a set of BT powerlines worked flawlessly.

What you want to achieve should work though. Perhaps monitor the line when turning on the adapters to see if it has any negative effect.
Logged
Plusnet FTTC 80/20 -  ECI now Huawei cab
retx low @ 3dB target SNRM
Zyxel VMG1312-B10A bridged with 1508 MTU + Asus RT-AC68U running Asuswrt-Merlin
 

anything