Broadband Related > Broadband Hardware

ZyXEL VMG1312-B10A Help Required

(1/5) > >>

hacktrix2006:
Hi all so i have a  ZyXEL VMG1312-B10A now, i have managed to get my supervisor password and change both admin and supervisor passwords. I am using the Jumboframe firmware as well.

However before i go to connect it to the DSL socket i am trying to get the setup just like my old HG612 to Archer V2600 where i had the following setting

192.168.3.1 (DSL Bridge HG612)
|
192.168.1.2 (Archer V2600 with DHCP enabled access point mode)

now i was able to access said webgui on HG612 after putting in a static router to which i used the same setup for the  ZyXEL VMG1312-B10A where i am using the following

Destination network address: 192.168.1.0
Subnet mask: 255.255.255.0
Default gateway: 192.168.1.2
Interface: LAN/br0

Firewall: Disabled

However i can not ping it which means i can not open the webgui when i am connected to the VR2600.

So anyone have any ideas that could help me with this please.

johnson:
So previously you had the HG612 set to 192.168.3.1? And you have set the Zyxel to something different now?

Are you using a single cable or 2?

hacktrix2006:
Originally i had the HG612 set to 192.168.3.1 but as that died the zyxel is replacing the hg612.

So i set the VMG1312-B10A into bridge mode so it acts as the soul modem and then the vr2600 which is ip 192.168.1.2 is the router for DHCP and wifi stuff.

Now on the HG612 i was able to connect to it via the VR2600 just by simply adding a route to the hg612 using

dest: 192.168.1.0
sub: 255.255.255.0
gw: 0.0.0.0
Br0

however this is not working even with firewall off on the zyxel modem.

I am currently only using one cable right now between both routers trying to get this to work before connecting it to the DSL line (As i don't want to keep rebooting and cause DLM to kick in)

johnson:
Ok, sorry for being slow, but what IP do you have the Zyxel set to?

hacktrix2006:
Network Topology incoming

Zyxel IP: 192.168.3.1
Zyxel Subnet: 255.255.255.0
DHCP: Off
Firewall: Off

VR2600 IP: 192.168.1.2
VR2600 Subnet: 255.255.255.0
DHCP: on

VR2600 2nd IP: 192.168.3.2
VR2600 Subnet: 255.255.255.0

Settings for route on zyxel as to the guide i am using which is AAISP is set to

Des: 192.168.1.0
Sub: 255.255.255.0
Gate: 0.0.0.0
Default/BR0

but even with the firewall rules off on the zyxel i can not ping nor connect to the Webgui which i was able to do before with the same settings which is what is puzzling me.

Navigation

[0] Message Index

[#] Next page