Kitz ADSL Broadband Information
adsl spacer  
Support this site
Home Broadband ISPs Tech Routers Wiki Forum
 
     
   Compare ISP   Rate your ISP
   Glossary   Glossary
 
Please login or register.

Login with username, password and session length
Advanced search  

News:

Author Topic: Hlog and impedance  (Read 548 times)

konrado5

  • Reg Member
  • ***
  • Posts: 896
Hlog and impedance
« on: May 04, 2018, 01:53:54 AM »

I've found in ITU-T G.922.3 specification some information about Hlog measurement accurracy (page 113).
Quote
The accuracy requirements for the downstream HLOGps (HLOGps_ds and HLOGps_us) shall
apply only for those frequencies where the loop impedance (Z loop ) falls within the following ranges:
impedance magnitude is between 100 Ω and 120 Ω;
impedance imaginary component is between 20 Ω and 0 Ω.
The loop impedance (Z loop ) is defined as the impedance seen by the transceiver under test, looking
into the loop, including the transmitting transceiver connected to the loop at the far end
Does somebody know what is about?
Logged

Weaver

  • Addicted Kitizen
  • *****
  • Posts: 6386
  • Retd sw dev; A&A; 4 7km ADSL2; IPv6; Firebrick
Re: Hlog and impedance
« Reply #1 on: May 04, 2018, 03:04:17 PM »

I wonder which operators / lines they might be talking about?
Logged

konrado5

  • Reg Member
  • ***
  • Posts: 896
Re: Hlog and impedance
« Reply #2 on: June 18, 2018, 11:26:25 PM »

I've found also appendix VIII of g 922.3 specification.
Quote
This appendix provides a discussion regarding the effects on measured accuracy of Hlog when there
is a mismatch between a nominal loop termination impedance of 100 Ω and the actual termination
impedance (Z ATU ) provided by the ATU. This appendix is meant to provide additional technical
details regarding clause 8.12.5.1.1 on accuracy requirements for the HLOGps test parameter.
http://www.itu.int/rec/T-REC-G.992.3-200904-I/en
Logged

konrado5

  • Reg Member
  • ***
  • Posts: 896
Re: Hlog and impedance
« Reply #3 on: June 18, 2018, 11:58:32 PM »

Logged

konrado5

  • Reg Member
  • ***
  • Posts: 896
Re: Hlog and impedance
« Reply #4 on: July 25, 2018, 06:29:22 PM »

I wonder which operators / lines they might be talking about?
They are not talking about specific lines/operators. They are talking about ADSL technology. I wonder if it is often that circuit have impedance causing hlog measurement errors.
Logged