Kitz ADSL Broadband Information
adsl spacer  
Support this site
Home Broadband ISPs Tech Routers Wiki Forum
 
     
   Compare ISP   Rate your ISP
   Glossary   Glossary
 
Please login or register.

Login with username, password and session length
Advanced search  

News:

Pages: 1 2 [3]

Author Topic: FTTC - Line Length and Attenuation Calculations  (Read 44887 times)

Bald_Eagle1

  • Helpful
  • Kitizen
  • *
  • Posts: 2721
Re: FTTC - Line Length and Attenuation Calculations
« Reply #30 on: January 24, 2012, 10:59:45 PM »

This document looks interesting / relevant:-
JD Loop Analysis using DSL Data HLog, QLN, SNR, and BPT



Logged

waltergmw

  • Kitizen
  • ****
  • Posts: 2776
Re: FTTC - Line Length and Attenuation Calculations
« Reply #31 on: January 24, 2012, 11:53:31 PM »

Hi c6em,

Unless you have something very special I very much doubt the cable is armoured.

If it is, just watch out in case it is a steel tape armour which is almost certainly a 414 V three phase power cable, usually a minimum of around 25 mm diameter (or larger). A single phase house service is around 20 mm.

If it is steel wire armour around 30 mm dia. then you've probably found the 11 kV high voltage cable !

Kind regards,
Walter
Logged
Pages: 1 2 [3]