Topic: FTTC - Line Length and Attenuation Calculations (Read 47651 times)

Bald_Eagle1 · « **Reply #30 on:** January 24, 2012, 10:59:45 PM »

This document looks interesting / relevant:-
JD Loop Analysis using DSL Data HLog, QLN, SNR, and BPT

waltergmw · « **Reply #31 on:** January 24, 2012, 11:53:31 PM »

Hi c6em,

Unless you have something very special I very much doubt the cable is armoured.

If it is, just watch out in case it is a steel tape armour which is almost certainly a 414 V three phase power cable, usually a minimum of around 25 mm diameter (or larger). A single phase house service is around 20 mm.

If it is steel wire armour around 30 mm dia. then you've probably found the 11 kV high voltage cable !

Kind regards,
Walter

News:

Author Topic: FTTC - Line Length and Attenuation Calculations (Read 47651 times)

Bald_Eagle1

Re: FTTC - Line Length and Attenuation Calculations

waltergmw

Re: FTTC - Line Length and Attenuation Calculations