Kitz Forum
Broadband Related => Telephony Wiring + Equipment => Topic started by: hushcoden on April 07, 2021, 08:25:36 AM
-
My G.fast line went live yesterday afternoon and so far so good :fingers:
The master socket 5C is on a closet while the modem/router is in the living room (I assume the builder made some sort of extension from the master socket to the living room).
The OR engineer wanted to install a new G.fast faceplate (here (https://www.run-it-direct.co.uk/adsl-vdsl-faceplates/g-fast-openreach-faceplate/) the details) but before we tried with my current setup, that is a G.fast (https://www.run-it-direct.co.uk/adsl-vdsl-filters/gfast-plug-in-filter) microfilter and it worked ::)
I was wondering if anyone on G.fast using that specific new faceplate could share his/her own experience - I'd really like to stay this way...
Tia.
-
AFAIK it makes zero difference. All a microfilter does is limit only the voice tones to the BT phone socket, in that respect any good DSL microfilter will work fine.
I was using an ADSL filter on VDSL for ages, I only eventually replaced it because it developed a fault.
-
Thanks Alex, so it's safe to say I don't need that new G.fast faceplate, I won't gain speed or anything else...
-
The G.Fast faceplate might make a small difference if the REIN and common-mode noise elements have been optimised for G.Fast. Another thing, if you don't have a phone plugged into the current microfilter then you don't actually need it there at all.
:)