Kitz Forum
Broadband Related => Broadband Hardware => Topic started by: banger on August 04, 2017, 03:38:39 PM
-
So I took delivery of a brand new 1312 italk branded router. It wouldn't accept the standard admin password despite the italk documentation saying it was that. I did a factory reset and bang we're in with default password.
Interesting to note it was on V6 of the firmware so upgraded that to V12 and loaded a backup configuration from disk. Interesting to note that the backup configuration must contain the supervisor password as I can now log in with my password from my other router on V12 after loading the config file.
Only tested for 10 minutes but seems to sync a little slower at 68½ down whereas the other older one syncs at 71½ and after I swapped them back the old one showed the same sync. Must admit not extensive testing of the new spare one could have been a bad retrain but it is a spare in case the old one goes pop.
-
Just the SNRM must have been a wee bit lower at the time of a new retrain even a difference 0.1dB can shave of 500Kbps, I'm hoping your not one of those Broadband OCD users and are just getting used to how it all works :-\
-
Yes that is what I was thinking. I am slightly OCD lol. I have my eye on another italk 1312 for comparison. Just one more eh?
-
I am slightly OCD lol.
Don't tell anyone but I think we all have it ;)