Kitz Forum
Computers & Hardware => Networking => Topic started by: fletch on February 14, 2008, 01:47:28 PM
-
Hi all I;m with talktalk and next week they are going to install there own equipment in the local exchange,
Could you tel me if I may get any problems with using my wireless ADSL Gateway,
LINKSYS mod/ WAG54GS
Thank;s
fletch
-
Hiyas fletch.
No there shouldnt be any problems as long as your router settings are correct.
Some problems that Ive seen in the past after being LLU'd are usually down to the router being set as LLC/PPPoE based.
The BTw system is a bit flexible on some exchanges and will accept either.
Your settings should be
Protocol/Encapsulation :- PPPoA (PPP over ATM)
Multiplexing method: VC-BASED or VC-Mux
(On some routers the above 2 settings may be combined as "PPPoA VC-Mux".)
VPI = 0
VCI = 38
-
Thanks Kitz,
I have saved the setting you gave {just in case} :no:
Thanks fletch
-
good luck :)
-
good luck :)
I didn;t even notice the change over but got a speed increase from 1928Kbps to 4821Kbps download
And from 242 Kbps to 360 Kbps
So very happy
fletch
-
Nice one. :)
Out of curiousity whats your sync speed?
-
Nice one fletch - let's hope it stays that way! Fingers crossed for you mate
-
Nice one. :)
Out of curiousity whats your sync speed?
Kitz how do I check my sync speed :no:
-
Run a speedtest at www.speedtest.bbmax.co.uk
-
Thanks
It said
Download 2.84.5 KB/sec
Upload 30.8 KB/sec
-
Your router should give you your sync speed - which is the actual rate you connect to the exchange at.
You can find out how to get your linestats from most of the common modems/routers here.
http://www.kitz.co.uk/adsl/frogstats.htm