Hi Kitz,
As usual, thanks very much indeed.
I'm delighted to confirm that your instructions worked as shown below (MAC addreses expurgated).
It's also worth recording that this was the ONLY modem I could get to synchronise on a lousy line, even though it was a bit slow synchronising and then took several minutes to authenticate.
The following modems wouldn't even sync 585V7, DG834GT, & 2Wire.
Does anybody know how to get at the Linksys log?
Also whether this is still the most up to date firmware version(s)
Kind regards,
Walter
__________________________________________________
The following are the three commands for the Linksys / Cisco Wireless G ADSL2+ gateway WAG54G2 Manufactured 08 / 2008
S/N ST400 H84478
MAC a b c d e 9B
? circulating symbol No. 49344394
http://192.168.1.1/setup.cgi?next_file=DSL_status.htmhttp://192.168.1.1/setup.cgi?todo=debughttp://192.168.1.1/setup.cgi?next_file=adsl_driver.htm--- System Information ---
Vendor: Linksys
ModelName: WAG54G2
Firmware Version: 1.00.10 , 2008-08-01T20:20:49
Boot Version: 1.03
Hardware Version: 0.01
--- DSL Information ---
DSL Driver Version: E.25.41.39
DSL VPI/VCI: 0/38
DSL Status: Showtime
DSL Mode: G.Dmt
DSL Channel: 64
DSL Upstream Rate: 448000
DSL Downstream Rate: 288000
Down up
DSL Noise Margin: 31.5 dB 63.5 dB
DSL Attenuation: 8 dB 6.0 dB
DSL Transmit Power: 11.6 dBm 11.9 dBm
--- Wireless Information ---
Wireless Driver Version: 2.1.34
Wireless Status: Enabled
Wireless Standard Channel: 11- 2.462GHZ
Wireless SSID: linksys
--- Dynamic Information ---
LAN Mac Address: a:b:c:d:e:9B
WAN Mac Address: a:b:c:d:e: 9D
Wireless Mac Address: a:b:c:d:e: 9C