Ok, so the router arrived on time BUT the auto setup wizard didn't detect my BT G.Fast line, I guess the current firmware hasn't got a BT profile in it.
So a bit of manual tweaking was needed, when it couldn't connect to the internet it offered manual configuration.
The wizard was trying to use IPoE, so I changed it to PPPoE, then added the username: bthomehub@btinternet.com - password: bt
It now found the G.Fast line but it still wouldn't log into the BT server, at this point I skipped to the next setting, completed the wizard & exited.
Then in the main menu I went to Network Settings/Broadband, here I had to edit the VDSL settings:
VLAN was set to off, so I turned it on & entered 101 under the 802.1q setting (I didn't touch the 802.1p setting).
Clicked APPLY & after a short wait it logged in, then it worked fine.
I was pleasantly surprised to find the PSU comes with interchangeable plug-tops, & both UK & EU plug-tops were supplied.
============================================================================
xDSL Training Status: Showtime
Mode: G.fast Annex A
Traffic Type: PTM Mode
Link Uptime: 0 day: 1 hour: 44 minutes
============================================================================
xDSL Port Details Upstream Downstream
Line Rate: 50.307 Mbps 330.759 Mbps
Actual Net Data Rate: 50.011 Mbps 330.052 Mbps
Trellis Coding: ON ON
SNR Margin: 9.1 dB 12.3 dB
Actual Delay: 0 ms 0 ms
Transmit Power: - 1.6 dBm 0.0 dBm
Receive Power: 4.7 dBm 3.0 dBm
Actual INP: 607.0 symbols 550.0 symbols
Attainable Net Data Rate: 69.347 Mbps 490.381 Mbps
============================================================================