Hello,
I'm looking a some help with a glide router I've bought to have a play with, with a non-glide connection.
It's the Technicolor TG589vac v2. I got it from ebay, but it was brand new in packaging, and the enclosed documents confirm it only got sent out at the start of July. However, I cannot get onto the interface at all.
I've tried connecting two different laptops via ethernet (in all LAN ports, including port 4 incase it was in bridge mode), but all I get in ipconfig is
Ethernet adapter Ethernet:
Connection-specific DNS Suffix . :
Link-local IPv6 Address . . . . . : fe80::29d6:152e:72cb:8c45%16
Autoconfiguration IPv4 Address. . : 169.254.140.69
Subnet Mask . . . . . . . . . . . : 255.255.0.0
Default Gateway . . . . . . . . . :
The ethernet light on the front is on, as is the one on the port(s) I plug into, it even flashes suggesting there is some activity, but I just cannot get any joy out of it. Same for the wifi, the SSID is GLIDE (whereas the enclosed card and documents suggest it should be Glide0129658), and neither the password on the card, or the original one under the label on the router, are accepted. I can get round by connecting via WPS, but even with this, the wifi network shows as connected with no default gateway.
I've tried setting a static IP in my network settings, doing a winsock reset, but still get the same result.
I've also factory reset several times but still get the same issue.
I have a zen line and interestingly if I plug the DSL in it does sync and even the internet light goes green, which I wouldn't expect, given it shouldn't be able to auth on a zen connection.
It was only £10 so if all else fails I'll give it up as a bad job, but I just wondered if anyone had any suggestions or experience on this, before it goes in the bin!
TIA