I've just noticed after installing DSL stats on a RPI that g.inp and vectoring is enabled on my line. I think this was done about 3 months a go and the line speed went from 34mbps to 43 with a max attainable rate of 50mbps.
The cab I'm on is in a small village and I'm about 900mtrs from the cab (following paths and poles).
Here's the stats:
Stats recorded 24 Jan 2017 20:31:05
DSLAM/MSAN type: BDCM:0xa48c / v0xa48c
Modem/router firmware: AnnexA version - A2pv6F039g1.d24m
DSL mode: VDSL2 Profile 17a
Status: Showtime
Uptime: 4 days 19 hours 59 min 38 sec
Resyncs: 0 (since 23 Jan 2017 19:08:59)
DownstreamUpstream
Line attenuation (dB): 23.80.0
Signal attenuation (dB):Not monitored
Connection speed (kbps):439996435
SNR margin (dB): 9.36.4
Power (dBm): 12.82.3
Interleave depth: 161
INP: 45.000
G.INP: EnabledNot enabled
Vectoring status: 1 (VECT_FULL)
RSCorr/RS (%): 0.11570.0212
RSUnCorr/RS (%): 0.00000.0000
ES/hour: 0.050.63
I guess this trial is going national?