Hi,
I've recently had some problems with my 80/20 Plusnet FTTC connection. I have been using an unlocked HG612, with G.INP enabled my speeds were 74Mbps/15Mbps. A fault developed in the copper joints between the modem and the cabinet according to Plusnet, Openreach have now fixed the issue leaving me with the following stats:
modem info:
V100R001C01B030SP08
A2pv6C038m.d24j
DSLAM/MSAN type: BDCM:0xa44f / v0xa44f
Modem/router firmware: AnnexA version - A2pv6C038m.d24j
DSL mode: VDSL2 Profile 17a
Status: ShowtimeUptime: 11 hours 44 min 53 sec
Resyncs: 0 (since 27 Jul 2015 21:48:19)
Downstream UpstreamLine
attenuation (dB): 19.1 0.0
Signal attenuation (dB): Not monitored
Connection speed (kbps): 8607 5446
SNR margin (dB): 32.0 10.0
Power (dBm): 12.6 7.4
Interleave depth: 151 1
INP: 3.00 0
G.INP: Not enabled
RSCorr/RS (%): 0.0005 0.0956
RSUnCorr/RS (%): 0.0027 0.0000
ES/hour: 0 0
xdslcmd info --stats
xdslcmd: ADSL driver and PHY status
Status: Showtime
Retrain Reason: 1
Last initialization procedure status: 0
Max: Upstream rate = 6366 Kbps, Downstream rate = 24232 Kbps
Bearer: 0, Upstream rate = 5446 Kbps, Downstream rate = 8607 Kbps
Link Power State: L0
Mode: VDSL2 Annex B
VDSL2 Profile: Profile 17a
TPS-TC: PTM Mode(0x0)
Trellis: U:ON /D:ON
Line Status: No Defect
Training Status: Showtime
Down Up
SNR (dB): 32.0 10.0
Attn(dB): 19.1 0.0
Pwr(dBm): 12.6 7.4
After plugging in my ECI modem, the BT speedtest shows:
Download = 48.82Mbps, Profile = 56.1Mbps
Upload = 12.98Mbps, Profile = 20Mbps