Broadband Related > Broadband Hardware

ZyXEL VMG8924-B10A

(1/3) > >>

toulouse:
Hello all,
I am currently using my Billion 8800NL modem router, and would like to switch to my recently purchased 8924-B10A. When I tried setting it up a couple of weeks ago, I just could not get it to work with DSLStats (one of the best things since sliced bread !!!!) I think the problem was that I had not supplied the correct username / password combination to allow DSLStats to login to the device to enable it to collect the stats. There were many Error / Warning messages in the DSLStats Event Log suggesting that the program was unable to log in to the modem / router.

So my question is - how can I find the correct username / password combination to make DSLStats work with this device. I read through the complete topic about 8324 / 8924 Firmware versions, and I believe some of the username / passwords are only available with some of the firmwares. I currently have installed Firmware version 20, if that helps.

Thanks for any / all suggestions


toulouse

skyeci:
should be the admin password. can you login via telnet using the admin account? V18 works on my 8324

ktz392837:
Also remember only one telnet session at a time - or at least it is for me with my 8324.  Eg so if you are using dslstats ensure you are not telneted into the modem with Putty separately as dslstats will then not work.

toulouse:
Hello skyeci and ktz392837,

Thanks for replying, but just to check that I'm on the right lines, the username is admin and the password is a 4 digit number as provided in the accompanying documentation. Is that correct ?

I don't have the 8924 connected at the moment so I can't try the telnet login just yet, but I am hoping to do that either tomorrow or over the weekend.

toulouse

skyeci:
hopefully yes.. the admin password should it work will also be the required password for dsl stats with the user being admin.

Navigation

[0] Message Index

[#] Next page