Broadband Related > FTTC and FTTP Issues

Has Vectoring Been Applied to My Circuit?

(1/5) > >>

freelander:
Hi
I have had a resync in the early hours of the morning and my attainable has jumped from 49 to 61 and my snr has jumped from 7.9 to 16.1 but my down load has dropped a bit , I am banded at 43998 and on a 55 /10 line with idnet

Stats on  MDWS same as username if some one would just have a quick check for me please

Thanks
Chris

Dray:
I don't think you can tell on there,you have to look at the telnet output

lee111s:
What modem/router are you using?

Some report vectoring status.

freelander:
Thanks
Using a Zyxel 9325 B10B

just checked and showing ( below ) i presume vectoring 1 full is vectoring  applied , would it be worth asking idnet to try and get my banding lifted


DSLAM/MSAN type:           BDCM:0xa48c / v0xa48c
Modem/router firmware:     AnnexA version - A2pv6F039x.d26n
DSL mode:                  VDSL2 Profile 17a
Status:                    Showtime
Uptime:                     8 hours 55 min 23 sec
Resyncs:                   1 (since 13 Aug 2017 13:51:59)
         
            Downstream   Upstream
Line attenuation (dB):     26.0      0.0
Signal attenuation (dB):   Not available on VDSL2      
Connection speed (kbps):   43998      9578
SNR margin (dB):           16.1      6.4
Power (dBm):               12.8      3.0
Interleave depth:          4      1
INP:                       55.00      0
G.INP:                     Enabled      Not enabled
Vectoring status:          1 (VECT_FULL)      

RSCorr/RS (%):             0.0010      0.0000
RSUnCorr/RS (%):           0.0000      0.0000
ES/hour:                   1.19      0.91

lee111s:
Have you had a look in the GUI magement page?

Navigation

[0] Message Index

[#] Next page