In the summer I had a similar problem and Kcom Eclipse my isp wanted me to go back to ADSL from ADSL2 to try to see if my long 4.3kl line was better, it was.
I ask to go back to ADSL2 again (after I thought a noisy line had been fixed) the Downstream is steady but 'upstream' is all over the place, errors are not bad.
I think the REIN issues have been sorted on my neighbors security camera.
My line profile should be 6dB + 6dB but the up keeps going to about 18dB ! .
----------------------------------------------------------
Stats recorded 26 Nov 2016 11:50:31
DSLAM/MSAN type: IFTN:0x71c8 / v0x71c8
Modem/router firmware: AnnexA version - A2pv6C038m.d24j
DSL mode: ADSL2
Status: Showtime
Uptime: 13 hours 33 min 33 sec
Resyncs: 5 (since 25 Nov 2016 14:46:30)
Downstream Upstream
Line attenuation (dB): 49.0 29.3
Signal attenuation (dB): 50.1 29.5
Connection speed (kbps): 4199 444
SNR margin (dB): 7.3 14.1
Power (dBm): 0.0 12.8
Interleave depth: 32 1
INP: 1.00 0
G.INP: Not enabled Not enabled
Vectoring status: Unknown
RSCorr/RS (%): 0.0044 0.0000
RSUnCorr/RS (%): 0.0012 0.0000
ES/hour: 4.08 0
--------------------------------------------------------------------------------
xdslcmd info --stats
xdslcmd: ADSL driver and PHY status
Status: Showtime
Retrain Reason: 1
Last initialization procedure status: 0
Max: Upstream rate = 796 Kbps, Downstream rate = 5192 Kbps
Bearer: 0, Upstream rate = 444 Kbps, Downstream rate = 4199 Kbps
Link Power State: L0
Mode: ADSL2 Annex A
TPS-TC: ATM Mode(0x0)
Trellis: U:ON /D:ON
Line Status: No Defect
Training Status: Showtime
Down Up
SNR (dB): 7.2 14.6
Attn(dB): 49.0 29.3
Pwr(dBm): 0.0 12.8
ADSL2 framing
Bearer 0
MSGc: 59 10
B: 131 63
M: 1 1
T: 1 1
R: 10 0
S: 0.9982 4.5310
L: 1138 113
D: 32 1
----------------------------------------------------------------------------------------
Ping 31 ms
Download 3.25Mb/s That's Good for me.
Upload 0.37Mb/s But that is poor .
